Tuesday, September 30, 2014

Everyone Out Of The Tub!

There's been enough time spent soaking in the bath of Impervo.

Dedicated readers may recall what this bookcase looked like when the paint was still wet.  And before the carpet was laid.

It's had plenty of time to cure and reach it's natural level of sheen.  As a result we've finally been able to start unpacking boxes from when we first moved in.  (It will probably be a while before the final box is unpacked...)

Late last week I hung the door to the mechanical room.  Still needs a doorknob, though.  They are somewhere in my hardware collection in the basement.  That's a project for another day.

Up until this point we've been making regular trips to Target to replenish our supply of ping pong balls.  They kept disappearing behind the furnace.   I might have to send the shop-vac on a search and rescue mission in the mechanical room...

So we're almost ready to resurrect the world famous holiday ping pong tournament.

I know the master trophy is in a box here somewhere...

Monday, September 29, 2014

Your Barn Door is Open...

It's always good to do something a little unexpected.  A little twist gives the place some extra interest.

The layout in the attic and the routing of the mechanical items didn't leave a lot of space for a linen closet.  Which meant, of course, that a traditional door frame wasn't really going to work either.

So we ended up with this idea.  It turned out really well.  The door slides on the top rail to reveal a usable, small-ish linen closet.  The door is original to the house (see the door in the top photo of a previous post).  After scraping old junk off it, filling the voids from the old lock set, etc., it looks pretty good with a couple of new coats of Impervo.

Thursday, September 18, 2014

A Building Inspector Walks Into A Bar...

... and says "it's not a kitchen."

Perhaps he'll finally believe me.

We struggled a bit with how to light this part of the space given the nature of the ceiling.  We tried a number of different fixtures that didn't quite work out before finding these.  They are interesting little track lights with art glass "globes".  I installed them a week or so ago.

The plumber was here today doing all the final fixture installation in both the bar and bathroom.

Obviously this is not a kitchen sink...

A dishwasher will eventually go into the opening to the right of the sink.

I know, I know, I still have to install the knobs/pulls on the cabinet doors and drawers.

It goes without saying that the counter tops were installed earlier in the week as well.

At one point this was one large piece of stone.  However, in order to get it into the attic it had to be fabricated in three pieces.  They did a fantastic job of matching up the seams!

And it's a good thing they work with the floor tile.  Until the counters were installed we'd not seen them in the same place at the same time...

Monday, September 8, 2014

Look Ma; No Doors

The carpet installer wanted all the doors removed to make his life easier.  I was OK with that because I needed to prep them and wanted to get them outside anyway.

I've been trying to figure out how I can paint all the doors in one step.  Using saw horses is a pain - waiting for a side to cure completely before you flip it really slows down the process.

I have six doors to paint and have been thinking about how best to do it.  I don't recall where I first saw the idea, but I saw some guy using a rotisserie. He fabricated a stand for each end and installed a lag screw in the top and bottom of each door.  The lag screw rest on the stand or on a set of saw horses.  The you can spin the door around to paint both sides and edges in one pass.  Sort of like this.

I have six doors to paint and I like to do them all at once so I needed to modify that idea a little.

So I came up with this.  Insert a screw eye in the top of each door and hang each from a hook in the garage.  Then I have easy access to the entire door and each is hanging in its normal orientation.

I have only one left to prep (lying flat on saw horses at the left edge of the picture) and then I can get started painting.

Sunday, September 7, 2014

Oh, The Irony

This arrived in the mail yesterday shortly after The Incident.

I wonder if I can send it back in time?

Fire in the Hole!

Yesterday was far too exciting.  Both for me and Marty, the alarm system installer.  (Yes, those are new holes in the wall to the left of the door...)

Things were moving along pretty smoothly and for the most part he was able to use existing holes to run wires, etc.

Until it came time to run power to the control panel.

He'd drilled a hole in the hallway side of this wall and was using a "wet noodle" to fish a wire down to the outlet on the kitchen side of the wall.

I was sitting at the kitchen table and saw a flash just before I heard Marty say, "Uh oh!"

That's never good...

We both ran to the hallway, looked through the 1-inch hole, and saw flames licking up the stud cavity.

He ran out to his truck, grabbed the fire extinguisher, and started squirting in the hole from the hall-side and then from the kitchen side past the outlet into the wall.  Meanwhile, I ran down to the basement and started turning off all the kitchen breakers.  On the way back up I grabbed a hammer, pry bar, drywall saw, and a shop light.

We didn't see any more flames, so plugged in the shop light to check the outlet's power before opening up the wall.

And the light still worked.

So I ran back downstairs and began turning off more breakers.  With each one Marty said, "Nope; still on!"

WTF!?

There was only one breaker left and it was marked "Water Heater".

Sure enough, that was the one supplying power to this outlet...

On my next trip up the stairs I found my circuit tester just to be safe.

Then I started getting into the wall.  Both Marty and I wanted to make sure the fire was completely out.

Of course, I discovered that there is a 3/8-inch layer of drywall over the plaster in this room (nice wallpaper by the way).  I'd long suspected so because the reveal on the door and window casings isn't right in the kitchen.  (Note in this picture - all I've done is remove the overlay-ed drywall; those holes in the plaster were already there hiding behind the drywall...)

After verifying that there was no more fire and that no wires were energized, I could start investigating while Marty called his Boss.

It's a good thing he acted quickly at the beginning or our next call would have been to the fire department...

So I think here's the cause: the insulation is not intact on the third wire from the left.  His "noodle" chain hit this wire and then arced when it touched the metal outlet box in the next picture.

Clearly I said a lot of bad words about the last ding-dong to play with this junction box.  And if you don't see at least a couple things wrong with this picture then you shouldn't be playing with electricity.

Seriously.

Lastly, here's the picture of the outlet on the kitchen side.

Originally, it was located it the lower left corner of the hole.  Those with sharp eyes will notice that it doesn't look like it will reach that location any longer.  And they'd be right.  That's because there was a big nick in the romex sheath about 2 inches above the outlet box; so I fixed it.

Oh yeah; the ground wire wasn't attached to the metal box.

Nor were the side terminals wrapped with electrical tape to prevent them from hitting the side of the box and shorting out (note fancy new red electrical tape that is now present)..

Not pictured is the kitchen towel that was stuffed between the outlet box and the stud on the left edge of the hole (apparently to keep it in place because the box wasn't attached to anything!).

Also not pictured is the broken nail-on plastic outlet box that was lying at the bottom of the stud cavity along with several other pounds of construction debris.

Maybe I should move on to happier thoughts before my head explodes.

Ah, that's better...

I'm not worried about the holes in the wall; the kitchen needs to be gutted to the studs anyway and I just got an early start on it.  ;-)

Before Marty finished up the rest of the alarm installation, his Boss stopped by to make sure everything was OK and we had a great talk.  Turns out our kids go to school together.  I'd recommend these guys if you need an alarm system.

Just mention that you'd like them to find a different way to test the smoke alarm.  ;-)

Thursday, September 4, 2014

A Crane Nova

No, that's not some sort of crazy anagram.  It's the pedestal sink that's going into the attic bathroom.

It was the original sink in the master bathroom and it is still in fantastic condition (once I wipe the dirt off).  The guys at Gopher Plumbing helped us identify it.  They've been very helpful in trying to track down replacement parts for the valve stems, etc. but have so far struck out.  If you need plumbing parts, their customer service can't be beat.

Unfortunately even their secret custom vendors have never seen anything quite like it.  They said the vendor can try to reproduce the valve stems, given the originals (which I have), but no guarantees and it'll be costly.  And, "While you're making two, you should make an extra set of replacements. Someday you'll need them."  If they last as long as the originals, that won't be a problem I need to worry about...

I'm tempted, but we'd still have to source the missing handle - realistically a pair because I'm certain we'll never find a match to the one we have.

Likely we'll end up buying a new faucet.

Monday, September 1, 2014

Another Chandelier

Normally I end up installing a chandelier the night before some big party.

At midnight.

No parties this time.  Fortunately.

The ceiling is 13 feet high in this room and this thing weighs over 50 pounds.  There's no sense rushing things when you're that high on a ladder.

It's not that I'm afraid of heights so much as I'm afraid of falling.  ;-)

We hung it slightly higher than one normally would because it looked better in the space.  In addition it gives us maximum flexibility when entertaining - it won't get in the way of any full court shots...